Fixture Plate for HAAS UMC-1000Adding a fixture plate to your UMC-1000 results in dramatically reduced setup time and aggravation. All of our foundation plates are marked with alphanumeric labeling on a 2" grid, allowing for most of your fixtures to seamlessly mount to the plate. Each hole is outfitted with a 1/2-13 thread as well as a .501 ID bushing for simultaneous locating and mounting. The foundation will mount and locate straight to the T slots of your machine tool. Additionally, these plates can now be outfitted with our Stallion Lock system, which allows for quick change of setups within your mill.
|
|
▪ Precision ground surface
▪ 25" ⌀ working surface
▪ Guaranteed flatness and parallelism of .001 per 24 inches
▪ Plain or Drilled/Tapped with locator bushings
▪ 2 inch grid pattern used to allow for a wide variety of workholding products
▪ Bushings in every other hole, or every hole if preferred
▪ Plate doweled to match T-slot pattern of customer's machine tool
▪ 25" ⌀ working surface
▪ Guaranteed flatness and parallelism of .001 per 24 inches
▪ Plain or Drilled/Tapped with locator bushings
▪ 2 inch grid pattern used to allow for a wide variety of workholding products
▪ Bushings in every other hole, or every hole if preferred
▪ Plate doweled to match T-slot pattern of customer's machine tool
|
|
|
|
|
|
CATALOG |
Install |
Video |
CAll us |
